Synopsis
		sfsuplane > out.rsf nt=NT ntr=NTR dt=DT offset=OFF npl=NPL taper=0 dip1=0 len1=3*ntr/4 ct1=nt/2-1 cx1=ntr/2-1 dip2=4 len2=3*ntr/4 ct2=nt/2-1 cx2=ntr/2-1 dip3=8 len3=3*ntr/4 ct3=nt/2-1 cx3=ntr/2-1 liner=0

Command line should be: sfsuplane in=NULL >file.rsf
(There should be at least one parameter in command line because of sf_init(argc,argv))

Parameters
		int ct1=nt/2-1   int ct2=nt/2-1   int ct3=nt/2-1   int cx1=ntr/2-1 set defaults and/or get parameters for plane 2   int cx2=ntr/2-1 set defaults and/or get parameters for plane 3   int cx3=ntr/2-1 check if user wants the special output specified   float dip1=0   float dip2=4   float dip3=8   float dt=DT   int len1=3*ntr/4   int len2=3*ntr/4   int len3=3*ntr/4   int liner=0   int npl=NPL   int nt=NT   int ntr=NTR   float offset=OFF   int taper=0 set defaults and/or get parameters for plane 1